Pitco Frialator SG Manual do Utilizador Página 6
- Página / 48
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
4
L20-206 Rev 2 (07/02)
listed on the data plate mounted on the inside of the fryer door..
LIGHTING INSTRUCTIONS
a. Fill kettle before lighting.
b. Turn combination gas valve knob to “ON” position.
c. 1. Solid State Thermostat: Switch melt switch to desired position. Turn the Thermostat
knob to desired temperature. Turn the power switch to the "ON" position, the fryer is equipped
with a matchless ignition system and will automatically light the pilot, and heat up to set
temperature.
2. Digital Controller: Press the
button on the controller panel to turn fryer ON, the fryer is
equipped with a matchless ignition system and will automatically light the pilot, and heat up to
set temperature.
3. Computer Controller: Press the
button on the controller panel to turn fryer ON, the fryer is
equipped with a matchless ignition system and will automatically light the pilot, and heat up to set
temperature.
d. Delighting - wait 5 minutes before attempting to relight the pilot to allow for any gas in the fryer to
dissipate.
WARNING
DO NOT TURN COMBINATION GAS VALVE KNOB TO THE “ON” POSITION UNTIL
VESSEL IS FULL OF WATER OR SHORTENING. TURNING THE KNOB TO “ON” WITH VESSEL
EMPTY WILL DAMAGE THE VESSEL OR COMPONENTS AND VOID WARRANTY.
INITIAL CLEANING
When the fryer is shipped, many of its parts are covered with a thin coat of oil for protection. Before the fryer is ready
for cooking it must be cleaned. This will remove the oil coating and any foreign matter that may have accumulated during
storage and shipment. Perform the cleaning as described below.
a. Fill the tank with water and add one packet of Pitco fryer cleaner or a mild detergent, and turn gas valve knob
to ON position.
b. 1. Solid State Thermostat: Turn melt switch to the "MELT" position. Turn the Thermostat
knob to the lowest temperature setting (250
0
F). Turn the power switch to the "ON" position,
the fryer is now in the boil-out mode which will prevent the fryer from boiling over. Note:
do not leave the fryer unattended during this operation. Once the fryer has heated up to
approximately 195
0
F, allow it to operate for 15 minutes to allow any build up in the tank to
soften.
2. Digital Controller: Press the button on the controller panel to turn fryer ON. The fryer
will automatically switch into the boil-out mode which will prevent the fryer from boiling
over. Note: do not leave the fryer unattended during this operation. Once the fryer has
heated up to approximately 195
0
F, allow it to operate for 15 minutes to allow any build up
in the tank to soften.
3. Computer Controller: Press the button on the controller panel to turn fryer ON. The
fryer will automatically switch into the boil-out mode which will prevent the fryer from
boiling over. Note: do not leave the fryer unattended during this operation. Once the fryer
has heated up to approximately 195
0
F, allow it to operate for 15 minutes to allow any build
up in the tank to soften.
NOTE
Do not leave the fryer unattended during cleaning. Never let the
water level go below the "Min Level" mark on the back of the tank.
Manuais e produtos relacionados com Fritadeiras Pitco Frialator SG
(20 páginas)
(20 páginas)
Bissell MAX 21H6 manuales
Manuales del propietario y guías del usuario para Aspiradora Bissell MAX 21H6.
Ofrecemos 1 manuales en pdf Bissell MAX 21H6 para descargar gratis por tipos de documentos: Manual de usuario
Comentários a estes Manuais